Charge Flow

Chapter 24: Current, Resistance, and DC Circuits

AP Physics C: Electricity & Magnetism
Advanced Theoretical Frameworks

24.1 Electric Current

Until now, our study of electromagnetism has focused on electrostatics—the behavior of stationary charges and the fields they produce. However, the most profound applications of electricity arise when charges are in motion. This movement of charge is known as electric current.

Mathematically, we define current (\(I\)) as the net rate at which charge passes through a specific cross-sectional area. In the limit as the time interval becomes infinitesimal, the instantaneous current is: \[ I = \frac{dQ}{dt} \] The SI unit of current is the Ampere (A), defined as one Coulomb per second (\(1 \text{ C/s}\)).

Figure 24.1: A standard single-loop DC circuit. Arrows indicate conventional current flow from the positive to the negative terminal.

Conventional Current vs. Electron Flow

By historical convention established by Benjamin Franklin, current is defined as the flow of positive charge carriers. In reality, in metallic conductors, it is the negatively charged electrons that move. These electrons move in the direction opposite to the conventional current.

Page 1

24.2 Circuit States

Before analyzing the laws that govern electrical flow, we must define the physical configurations that allow current to exist. A simple circuit consists of three essential elements: an energy source (like a battery), a conducting path (wires), and a load (like a resistor or lamp) that converts electrical energy into another form.

Closed Circuit

A closed circuit is one in which the conducting path is continuous and unbroken. This allows the electric field to exert a force on charge carriers throughout the entire loop, resulting in a steady-state current (\(I > 0\)).

Open Circuit

An open circuit occurs when there is a break in the conducting path (e.g., a switch in the 'off' position). In this state, the resistance of the air gap is effectively infinite, and no net charge can flow (\(I = 0\)).

Figure 24.2: Comparison of closed and open circuit states. Current requires a continuous loop of conducting material.

A third state, the short circuit, occurs when a very low-resistance path is created that "bypasses" the load. Because \(I = V/R\), an extremely small \(R\) leads to dangerously high currents, often resulting in rapid heating and damage to the power source.

Page 2

24.3 Current Density

Current is a macroscopic scalar quantity. To describe the flow of charge at a specific point in space, we define the current density (\(\vec{J}\)), which is a vector quantity. The magnitude of \(\vec{J}\) is the current per unit cross-sectional area.

The Flux Definition of Current

The net current through a surface is the flux of the current density vector:

\( I = \int \vec{J} \cdot d\vec{A} \)

For a uniform current flowing through an area \(A\) perpendicular to the flow, \(J = I/A\). In SI units, current density is measured in Amperes per square meter (\(A/m^2\)).

24.4 The Microscopic Model of Conduction

To understand what drives current, we must look at the microscopic level. In a conductor, "free" electrons move randomly due to thermal energy at speeds of approximately \(10^6 \text{ m/s}\). This motion is chaotic and averages to zero net displacement over time.

When an external electric field (\(\vec{E}\)) is applied, it exerts a force \(\vec{F} = -e\vec{E}\) on each electron. This force causes the electrons to accelerate. However, they do not accelerate indefinitely; they constantly collide with the stationary ions of the metal lattice.

Page 3

Drift Velocity (\(v_d\))

The result of collisions is a slow, net motion in the direction opposite to the electric field. This average velocity is called the drift velocity.

Consider a conductor with \(n\) charge carriers per unit volume, each with charge \(q\). The relationship between current density and drift velocity is: \[ \vec{J} = n q \vec{v}_d \] In metals, \(q = -e\), so \(\vec{J} = -n e \vec{v}_d\). Note that because \(e\) is negative, \(\vec{J}\) and \(\vec{v}_d\) point in opposite directions.

24.5 What is Resistance?

Resistance is the macroscopic manifestation of microscopic collisions between charge carriers and the material's internal structure.

Microscopic Scattering Model

Figure 24.3: Electrons lose kinetic energy and momentum during collisions with lattice ions. This energy is transferred to the lattice as heat (Joule Heating).

Page 4

24.6 The Drude Model

Paul Drude derived the relationship between current and electric field by assuming electrons gain a drift velocity between collisions. Let \(\tau\) be the mean free time.

The drift velocity is \(v_d = (e E / m) \tau\). Substituting this into \(\vec{J} = n e \vec{v}_d\): \[ \vec{J} = \left( \frac{n e^2 \tau}{m} \right) \vec{E} \]

Microscopic Ohm's Law

Defining Resistivity (\(\rho\)):

\( \vec{E} = \rho \vec{J} \)

Resistivity from microscopic constants:

\( \rho = \frac{m}{n e^2 \tau} \)

This derivation connects macroscopic resistivity to microscopic constants. Resistivity depends on carrier density (\(n\)) and the frequency of collisions (\(1/\tau\)).

Page 5

24.7 The Nature of Ohm's Law

Ohm's Law (\(V=IR\)) is an empirical relationship—it is a descriptive property of materials rather than a fundamental law of physics.

Ohmic vs. Non-Ohmic Materials

A material is Ohmic if its resistance remains constant over a range of voltages, leading to a linear \(I\)-\(V\) curve.

Figure 24.4: I-V characteristics for linear and non-linear components.

Differential Resistance

For non-linear components, we define differential resistance as the derivative: \[ r = \frac{dV}{dI} \]

Page 6

24.8 Resistance and Geometry

Resistance (\(R\)) is an extrinsic property that depends on the geometry of the conductor. For a uniform wire: \[ R = \rho \frac{L}{A} \]

Integral Form for Variable Geometry

For non-uniform cross-sections \(A(x)\), the total resistance is:

\( R = \int_0^L \frac{\rho}{A(x)} dx \)

24.9 Energy and Power

Power (\(P\)) is the rate at which electric potential energy is converted into other forms: \[ P = IV \] In a resistor, this energy is dissipated as heat: \[ P = I^2 R = \frac{V^2}{R} \]

Page 7

24.10 Internal Resistance

Every real-world EMF source, such as a chemical battery or a generator, has some inherent internal resistance (\(r\)). This resistance arises from the physical materials and chemical processes inside the source.

Figure 24.5: A real battery modeled as an ideal EMF \(\mathcal{E}\) in series with an internal resistance \(r\). The terminal voltage \(V\) is measured between points \(a\) and \(b\).

When the battery delivers a current \(I\), a potential drop \(Ir\) occurs internally. Consequently, the terminal voltage (\(V\)), or the voltage available to the external circuit, is less than the ideal EMF: \[ V = \mathcal{E} - Ir \]

Page 8

24.11 Network Reduction

Series

\( R_{eq} = \sum R_i \)

Parallel

\( \frac{1}{R_{eq}} = \sum \frac{1}{R_i} \)

24.12 Kirchhoff's Rules

Kirchhoff's Rules are essential for analyzing complex networks.

The Junction Rule

\( \sum I_{in} = \sum I_{out} \)

Conservation of Charge

The Loop Rule

\( \sum \Delta V = 0 \)

Conservation of Energy

Page 9

24.13 Matrix Methods

For complex networks, we utilize systematic Mesh Analysis: \[ \mathbf{R} \cdot \mathbf{I} = \mathbf{V} \]

24.14 Electrical Instruments

Ammeter

In series. Ideal \(R \to 0\).

Voltmeter

In parallel. Ideal \(R \to \infty\).

The Wheatstone Bridge

A balanced bridge allows measuring unknown resistance \(R_x\) with high precision.

Page 10

Chapter Summary

Foundational Concepts

Closed circuits allow flow; open circuits block it.
Ohm's Law is an empirical description of carrier equilibrium.

Master Equations

\( I = \int \vec{J} \cdot d\vec{A} \)
\( \vec{E} = \rho \vec{J} \)
\( \sum \Delta V = 0 \)

Page 11

Charge Flow Chapter V8

Charge Flow Chapter V8

Similar Materials

Final Review Answer Key

Olutoyin Makinde

Final Review Quiz

Olutoyin Makinde

Lab Success Study Guide

Olutoyin Makinde

Genetics Investigator Worksheet Challenge

Priyadarshini Bharath

Genetics Investigator Worksheet Support

Priyadarshini Bharath

Genetics Investigator Worksheet Standard

Priyadarshini Bharath

Human Genome Stations Activity

Priyadarshini Bharath

Human Genome Slides Deck

Priyadarshini Bharath

Human Genome Teacher Guide

Priyadarshini Bharath

Routine Breakdown Log

Elizabeth Whitver

Routine Breakdown Slides

Elizabeth Whitver

Routine Breakdown Guide

Elizabeth Whitver

EcoJustice Teacher Guide

Justice Blueprint Planner

Community Health Lab Worksheet

EcoJustice Slides

Waste Wise Teacher Guide

Taryn Sigl

Upcycle Vision Rubric

Taryn Sigl

Trash to Treasure Project Guide

Taryn Sigl

Bioaccumulation Deep Dive Primer

Taryn Sigl

Scientific Purge Rubric

Taryn Sigl

Daily Plastic Audit Log

Taryn Sigl

Zero Waste Quest Guide

Taryn Sigl

Portfolio Blueprint Worksheet

brittaink@urbandaleschools.com

Portfolio Showcase Teacher Guide

brittaink@urbandaleschools.com

Portfolio Showcase Slides

brittaink@urbandaleschools.com

Pivot Blueprint Worksheet

brittaink@urbandaleschools.com

Strategic Pivot Teacher Guide

brittaink@urbandaleschools.com

Business Reflection Slides

brittaink@urbandaleschools.com

Big Pitch Scorecard Rubric

brittaink@urbandaleschools.com

Grand Finale Teacher Guide

brittaink@urbandaleschools.com

Big Pitch Event Slides

brittaink@urbandaleschools.com

Speaker Rehearsal Log

brittaink@urbandaleschools.com

Stage Presence Teacher Guide

brittaink@urbandaleschools.com

Stage Presence Slides

brittaink@urbandaleschools.com

Deck Part 2 Blueprint

brittaink@urbandaleschools.com

Data Flow Teacher Guide

brittaink@urbandaleschools.com